Version 4.1
SHEET 1 1580 756
WIRE -512 -64 -528 -64
WIRE -368 -64 -512 -64
WIRE -112 -64 -288 -64
WIRE -80 -64 -112 -64
WIRE -80 16 -80 -64
WIRE -528 32 -528 -64
WIRE -528 144 -528 112
WIRE -80 144 -80 80
WIRE -80 144 -528 144
WIRE -528 160 -528 144
FLAG -528 160 0
FLAG -512 -64 Vin
FLAG -112 -64 Vout
SYMBOL voltage -528 16 R0
WINDOW 123 0 0 Left 0
WINDOW 39 0 0 Left 0
SYMATTR InstName V1
SYMATTR Value PULSE(0 1 0 10n 10n 5u 10u)
SYMBOL res -272 -80 R90
WINDOW 0 0 56 VBottom 2
WINDOW 3 32 56 VTop 2
SYMATTR InstName R1
SYMATTR Value 10R
SYMBOL cap -96 16 R0
SYMATTR InstName C1
SYMATTR Value 100n
TEXT 416 -168 Left 4 ;Instructions
TEXT -368 224 Left 2 !.tran 100u
TEXT 264 -112 Left 2 ;in the toolbar click on the voltage source "V". move the mouse down and click,\nright click on the voltage source you have dropped on the sheet,\nin the window that opens click on advanced.\nin the window that opens click on pulse, (or sine if you want that sort of voltage)\nyou now have several fields to fill in,\nyou don't have to fill in the fields... "delay", or "no. of cycles".\nI have chosen... Vinitial=0, Von = 1, Trise=10n, Tfall=10n, Ton = 5u, Tperiod=10u\nclick on okay\nnow click on the downward pointing arrow in the toolbar, and drop it on the sheet below the voltage source.\nthis is the earth symbol, you need an earth symbol connected or the simulation won't run.\nnow click on the squiggly line (resistor) symbol in the toolbar, and drop it on the sheet below,\nyou may also wish to use the rotate symbol towards the right of the toolbar to rotate the resistor symbol.\nnow click on the capacitor symbol in the toolbar, and drop it on the sheet below,\nnow click on the blue wire in the middle of the toolbar, this is the wiring up mode.\nconnect up the components.\nright click on the resistor, and in the window that opens give it a value.\nright click on the capacitor, and in the window that opens give it a value.\nclick on the ",ac" icon in the toolbar, in the window that opens analysis at the top should be transient,\nset stop time to 100u, click okay.\nin the toolbar click on "net", in the opening window set the net name Vin, click on okay,\nplace this net name on the wire at the input.\ndo the same for Vout.\nClick on run.... the cct should simulate taking more or less no time at all.\nclick on the net names Vin and Vout to plot their waveforms.